Panasonic UF-580 Service Manual page 173

5.1.7. Service Mode 7 (LBP Service Mode)
This Service Mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameter.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "7".
5 1) Press "START" for printer parameter settings.
Press "2" and "START" to get the printer information.
Ex: Enter "START" for printer parameter settings.
6 Press "3" and "START".
Then enter the number of pages.
Ex: Enter "50" and press "START".
7 Press "\/" or "/\" to select another Parameter Name
(See Table) or press "CLEAR" to return to step 4.
8 Repeat step 5 through 7 to request operation, or press
"STOP" twice to return to standby.
Sub-Code
1
2
1
3
\/ /\
2
\/ /\
Operation or Unit Condition
Parameter Name
PRINTER COUNTER
LBP FUSER RESET
OUT OF TONER
PRINT AVAILABLE
LBP MEMORY CAPACITY Shows the Page Memory Capacity.
Service Mode 7
Displays and resets the Printer and Paper
Cassette(s) counters.
Clears the LBP Fuser Error.
Sets the number of pages to print after low toner
is detected. (Factory default = 100, adjustable
from 0 - 999)
Shows the remaining number of allowable
printable pages after low toner has been
detected (Counter Only).
173
LCD Display
MMM-dd-yyyy 15:00
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
LP SERVICE MODE (1-2)
1:LBP PARAMETER SET
LBP PARAMETER SET
1.PRINTER COUNTER
LBP PARAMETER SET
3.OUT OF TONER
LP SERVICE MODE (1-2)
1.LBP PARAMETER SET
MMM-dd-yyyy 15:00
Description
00%
00%