Panasonic UF-580 Service Manual page 154

1. Printer Error Code Table
Error
Description of Problems
Code
00 No problem detected.
11 Timing Sensor did not turn ON within a
certain period of time.
(Original Cassette Feeder)
12 Timing Sensor did not turn ON within a
certain period of time.
(250 sheet Optional Cassette Feeder)
14 Timing Sensor did not turn OFF within a
certain period of time.
15 Paper Exit Sensor did not turn ON within a
certain period of time.
16 Paper Exit Sensor did not turn OFF within a
certain period of time.
17 Timing Sensor detected paper while
initializing the unit.
18 Paper Exit Sensor detected paper while
initializing the unit.
22 The temperature of the Fuser Roller
remained low even after the circuit was
activated.
23 Abnormally high Fuser Roller temperature
after the circuit was de-activated.
24 The temperature of the Fuser Roller was not
controlled within a certain margin.
25 Thermistor open.
(See Note)
26 Thermistor detected temperature over 392°F
(200°C).
(See Note)
31 The Tetragon Motor did not reach a constant
speed of 8,898 rpm (400dpi)/13,347 rpm
(600dpi) within a specified period of time.
32 The Tetragon Motor did not maintain a
constant speed of 8,898 rpm (400dpi)/13,347
rpm (600dpi).
36 HSYNC signal abnormal.
54 A/D Converter error.
61 Unit detected "No Toner Cartridge".
63 Unit detected "Printer Cover Open".
1. Recording Paper misfeeding, Paper Feed
Roller defective.
2. Drive Clutch defective.
3. Timing Sensor defective.
1. Recording Paper misfeeding, Paper Feed
Roller defective.
2. Drive Clutch defective.
3. Timing Sensor defective.
1. Recording Paper Jam.
2. Timing Sensor defective.
3. Incorrect paper size setting.
1. Recording Paper Jam.
2. Paper Exit Sensor defective.
1. Recording Paper Jam.
2. Paper Exit Sensor defective.
1. Recording Paper jammed in the unit.
2. Timing Sensor defective.
1. Recording Paper jammed in the unit.
2. Paper Exit Sensor defective.
1. Fuser Unit defective.
2. SC PCB defective.
3. Power Supply Unit defective.
1. Fuser Unit defective.
2. SC PCB defective.
3. Power Supply Unit defective.
1. Fuser Unit defective.
2. SC PCB defective.
3. Power Supply Unit defective.
1. Thermistor defective (Fuser Unit).
2. SC PCB defective.
1. Thermistor defective (Fuser Unit).
2. SC PCB defective.
3. Power Supply Unit defective.
1. LSU defective.
1. LSU defective.
1. LSU defective.
2. SC PCB defective.
1. SC PCB defective.
1. Toner Cartridge not installed.
2. Toner Sensor defective.
1. Printer Cover is not closed.
2. ILS PCB defective.
154
Cause