Panasonic UF-580 Service Manual page 128

Code Mode
200 RCV
212
XMT
RCV
301 XMT
RCV
331 XMT
390 STANDBY
RCV
PRINT
400 XMT
401 XMT
402 XMT
403 RCV
(Polling)
404 XMT
405 XMT
406 RCV
(Password
Comm.)
407 XMT
Fax Information Codes
Phase Description of Problem
C Decoding process is not completed
at the end of phase C.
A-E Interface error occurred between
the CPU and modem.
- System fault.
C 8-minutes timer error.
(Germany only)
- Interface error occurred between
the machine and the PC.
B T1 timer (35±5 sec.) elapsed
without detecting 300 bps signal.
B DCN was returned from receiver
while transmitter is waiting for CFR
or FTT.
B DCN was returned from receiver
while transmitter is waiting for
NSF/DIS.
B Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned)
B Transmitter received FTT after it
transmitted TCF at 2400bps.
Received RTN after
communicating at 2400 bps.
B XMT-Password mismatched.
RCV-Password mismatched.
Selective RCV incomplete.
D Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN.
Defective SC PCB.
Modem is defective. (SC PCB)
Software problem occurred. (SC PCB)
Software problem occurred. (SC PCB)
Firmware update error.
GDI print error.
(Perform the operation again)
Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
SC PCB (Modem) or MJR PCB are
defective.
Receiver is defective. (It may only be
transmitting CED)
Your machine's ID Number is not
programmed.
Possible incompatibility or incorrect
Password.
Receiver working in non-CCITT mode
only. (Possible incompatibility)
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
Receiver is defective. (Modem, MJR
PCB, etc.)
SC PCB or MJR PCB are defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of ONE-TOUCH, ABBR
telephone
number.
Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
SC PCB (Modem) or MJR PCB are
defective.
128
Cause