Before You Change The Preset Programmes - Danfoss TP4 User & Installation Instructions Manual

Before you change the preset programmes

Please Note
The unit must be programmed in sequence and EVENT times
cannot be programmed out of sequence.
The event 1 time setting can be set at any time of day (normally
in the morning). The time settings for events 2 to 6 can only be
placed between the previous setting and 1.59.
If you want to leave a preset time as it is, simply press PROG to
move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and the
programme set up to that minute will be active.
!
If at any time you get confused and need to reset the unit to the
preset programmes, press and hold the + , – ,
the same time.
& buttons at
GB
15