Table of Contents
Advertisement
18
Running Header
ELECTRIC LOCK DELAY
All gates installed with a maglock (connected to the JP6 connector/input) may have
the electric lock delay function programmed into the system. This delays the gate
from opening for a programmed number of seconds (1-10) when the operator is
prompted to open. After the delay, the operator will de-energize the maglock
(allowing the gate to unlock) and open the gate.
Display value of delay [off, 0-10 seconds].
GATE OPERATOR WARNING
This feature allows you to enable or disable the operator alarm that warns people
with beeps when the gate is moving. Display value of delay [off, 0-10 seconds].
RESET TO DEFAULT
Select Yes+/No- to reset operator to factory defaults.
SINGLE BUTTON
The Single Button (connected at the J8 input connector) programming feature
allows you to configure the single button function (i.e., how the gate reacts after you
press the single button).
Selectable options include the following:
GATE CONDITIONS
OPENING
CLOSING
AT MID-STOP
If the gate is
OPENING
CLOSING
AT MID-STOP
Doc 01-G0181
Rev A
PROGRAMMABLE FUNCTIONS POSSIBLE
Table 2: Programmable Options
and you select
Stop. If "TIMER TO CLOSE" is activated
STOP
(see p. Error! Bookmark not defined.), the
gate closes after timer elapses.
Continue to open—does not allow you to
OPEN ONLY
stop gate using single button.
Stop. If activated, "TIMER TO CLOSE"
STOP, NO TMR RST
function will not occur.
STOP
Stop.
REVERSE
Stop and then reverse to the open position.
MID-STOP OPEN
Travel to the open position.
MID-STOP REVERSE
Close if the gate was previously opening.
Table 3: Single Button Functions
STOP
OPEN ONLY
STOP, NO TMR RST
STOP
REVERSE
MID-STOP OPEN
MID-STOP REVERSE
the gate will
Advertisement
Table of Contents
