Table of Contents
Advertisement
17
Operator Programming Menu (LCD Screen)
Operator Programming Menu
(LCD Screen)
Programming occurs on a 5-button, 2-LED membrane switch located on top of the
control box (see Error! Reference source not found.). Programming instructions
appear on a 2-row, 16-character LCD screen.
NOTE: This chapter serves as an overview of the SW2200's programming
functions and features. For more detailed instructions, refer to the
SLMAX/SW2200 Programming Manual.
Definitions and Options
GATE STATUS
The following status conditions will be displayed during normal gate operations:
Closed: Gate is in the closed condition and has not received any
commands to run.
Closing:
Midstop: Gate in any position other than closed or open and has not
received any run commands.
Opening: The operator has received a command to open and is opening
the gate.
Open: Gate is in the open condition and has not received any commands to
run.
LIMITS MENU
You may select the limits menu by scrolling thru the menu buttons. This menu will
be visible if the operator does not have limits already set (operators are sent from
the factory without limits).
NOTE: See Basic Setup and Device Connections for limit setting
procedures.
LOOP MENU
This feature allows you to program the desired loop function using the J4 inputs (A,
B, and C). Loop types include:
Open Loops
Safety Loops
Shadow Loops
TIMER TO CLOSE
This feature allows you to set the time (in seconds) the gate stays open prior to
closing automatically. Display time value [off, 0-120 seconds].
Doc 01-G0181
Rev A
Advertisement
Table of Contents
