Glass - Enerzone Solution 1.6 User Manual

If the paint becomes scratched or damaged, it is possible to give your wood stove a brand new
look, by repainting it with a 650
surface to be repainted with fine sand paper, clean it properly, and apply thin coats (2) of paint
successively. To retrieve the original finish, use the paint supplied by the manufacturer.
4.2

GLASS

Under normal operation the glass is designed to stay clean. Glass cleaning may be required
when burning damp wood and/or when burning slow fires. In general if the glass is not staying
clean then the unit is being under fired. Dirty glass may be self cleaned by burning a hot fire
(i.e. dry wood and opened draft controls) for a couple of hours. Good burning techniques will
result in clean glass.
Hand clean the glass only when the fire is out and the stove is cold. A light film can usually be
cleaned with paper towel and water. If heavy cleaning is required, a ceramic glass cleaner or
polish is recommended, and should be rinsed off with water for best results.
To change the glass remove the 6 glass retainers and metal frame. Remove damaged glass and
install the new one in place. Make sure you have a gasket around the replacement glass.
Reinstall the metal frame and secure it with the glass retainers.
Do not abuse the door glass by striking, slamming or similar trauma. Do not operate the stove
with the glass removed, cracked or broken.
The glass must be replaced by a genuine part only. Failure to follow instructions
or use of different material may result in property damage, bodily injury, or even
death.
o
C heat resistant paint. For this purpose, simply scrub the
32