Getting Information Through The Onboard Lcd; Figure 15 Mph2 Onboard Lcd And Control Keys; Figure 16 Mph2 Onboard Lcd Layout - Emerson Network Poewr MPH2 User Manual

3.1.1

Getting Information Through the Onboard LCD

The MPH2's main screen is displayed when the rack PDU is first powered up; see Figure 3. The
onboard LCD returns to the main screen from any other view after 5 minutes of inactivity (no keys
being pressed).
The Left and Right arrow keys below the onboard LCD move the cursor across the bottom of the
screen. When the cursor is over the desired symbol, press the Select key to display information about
that portion of the MPH2. The keys permit moving one level at a time through the levels of the MPH2
menus.
Example: Use the arrow keys to move the cursor over branch names (A or B) or outlet
names (numbers 1 - 8). Press the Select key and the screen displays information about the selected
branch or outlet. The screen retains the view if no key is pressed for 5 minutes. After 5 minutes of
inactivity, the onboard LCD returns to the main screen.

Figure 15 MPH2 onboard LCD and control keys

MPH2 LCD Keys
and LED's
(Main Screen Example)

Figure 16 MPH2 onboard LCD layout

Input Level
Metered
Information
Phase or
Line Voltage
MPH2 Unit
Identification
(Always shows
numeral 1)
® ™
Emerson MPH2
LCD
MPH2
121.1V 359W
1
Left Arrow Key Select Key
MPH2
121.1V 359W
1
Power Consumption
Alarm Indication
by Connected Load
in Watts
™
MPH2 Managed Rack
Power Distribution
2.96A
RX L1
2kWh
i
TX
Right Arrow Key
Bar Graph of
Input Current
2.96
A
2kWh
i !
MPH2 Rack PDU
Information
20
Operation
Line
Input
Status
LED's
L3
L2
Input Current
Level in Amperes
Energy used in kWh
Link to Receptacle Level