Temperature/Humidity Sensor; Figure 14 Inserting The Spring Nut Into A T-Slot - Emerson Network Poewr MPH2 User Manual

To install an RPC BDM in a rack:
1. Determine the mounting location.
2. Insert a spring nut into a T-slot on the frame member where the RPC BDM will be installed.

Figure 14 Inserting the spring nut into a T-slot

Insert a spring nut
into a T-slot...
3. Insert the MPH2 rack PDU screw into the spacer sleeve.
4. Insert the MPH2 rack PDU screw into the spring nut and tighten securely with a flat-head
screwdriver.
5. Hang the RPC BDM on the screw with the hooded mounting slot on the back of the RPC BDM.
6. Connect the RPC BDM to the RPC2 with an Ethernet cable.
7. Be certain to connect the cable to the correct port on the RPC2.
2.5.2

Temperature/Humidity Sensor

Optional Liebert
in the rack. Liebert SN sensors are designed for installation in Emerson racks without tools, but each
may be placed in any area to monitor temperature and humidity levels. Each connects to the RPC2
communications module, which makes readings available to other monitoring methods.
To install a sensor in a rack:
1. Insert the sensor bracket base into one end of the sensor support.
2. Snap the sensor into the other end of the sensor support.
3. Choose where in the rack to install the sensor assembly.
NOTE
Emerson recommends placing the sensor in the area of the rack that is likely to be warmest.
That location helps determine extreme conditions that can cause equipment damage.
4. Hold the sensor bracket on a T-slot on the Emerson rack frame where the sensor will be placed.
5. Insert the included quarter-turn fastener through the rectangular hole in the sensor bracket base
and into the T-slot.
6. Turn the fastener clockwise 90 degrees, a quarter of a turn.
7. Route the sensor cable to the RPC2 communications module and insert it into the card's external
sensor port.
NOTE
For more information, see the RPC2 user manual, SL-20841, available at Emerson's Web site,
http://www.emersonnetworkpower.com
® ™
Emerson MPH2
... then flip it so that it
is square in the slot
SN temperature/humidity sensors are available to assist in monitoring conditions
®
18
Installation