Solving Problems; Checking The Printer Status; Checking Messages On The Lcd Screen - Epson L565 User Manual

User's Guide

Solving Problems

Checking the Printer Status

Checking Messages on the LCD Screen

If an error message is displayed on the LCD screen, follow the on-screen instructions or the solutions below to
solve the problem.
Error Messages
Printer Error 0xXX
Turn the power off and on again. For details, see
your documentation.
A printer's ink pad is nearing the end of its
service life.
Please contact Epson Support.
A printer's ink pad is at the end of its service life.
Please contact Epson Support.
Communication error.
Check if the computer is connected.
Invalid IP address and subnet mask.
Enter them correctly. See your documentation.
No dial tone detected.
Recovery Mode
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs. The need for replacement of the pad does not mean that your
Solving Problems
Solutions
Remove any paper or protective material in the printer. If the error
message is still displayed after turning the power off and on again,
contact Epson support.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part. The message will be displayed
until the ink pad is replaced.
x
Press the button to resume printing.
Contact Epson or an authorised Epson service provider to replace the
ink pad*. It is not a user-serviceable part.
Connect the computer and the printer correctly. If you are connecting
over a network, see the Network Guide. If the error message is still
displayed, make sure that EPSON Scan and Epson Event Manager are
installed on the computer.
See the Network Guide.
This problem might be resolved by selecting Setup > Fax Settings >
Basic Settings > Line Type and then selecting PBX. If your phone
system requires an external access code to get an outside line, set the
access code after selecting PBX. Use # (hash) instead of the actual access
code when entering an outside fax number. This makes connection
more secure.
If the error message is still displayed, set the Dial Tone Detection
settings to disabled. However, disabling this feature may drop the first
digit of a fax number and send the fax to the wrong number.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
99