Table of Contents
Advertisement
Before Requesting Help
Problem
The unit does not display the
caller's name and/or phone
number.
The handset display goes to
the standby mode while
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
(LOCATOR/INTERCOM)
not function.
You cannot redial by
pressing
(REDIAL/PAUSE)
76
•You need to subscribe to a Call Display
service from a telephone company.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Call Display information.
•Telephone line noise may be affecting
the Call Display information.
•Do not pause for over 60 seconds while
searching.
•The line mode selection is incorrect. See
page 17.
•The handset is too far from the base unit.
does
•The handset is engaged in an outside
call, viewing the Caller List/directory list
or listening to messages. Wait until the
IN USE/CHARGE indicator light goes
out.
•If the last number dialed was more than
.
32 digits long, the number will not be
redialed correctly.
•Access numbers entered after pressing
(TONE)
redialing.
•The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 29). If another
number has been dialed first, it will
operate as a pause button (p. 52).
Remedy
will not be included when
Advertisement
Table of Contents
