Lcd Panel Voltage Setting (Jp6); Lcd Clock Signal Selection (Jp7); Ethernet Tx/Rx/Link Led Connector (Jp8) - Aaeon MB-668 Manual

MB-668

LCD Panel Voltage Setting (JP6)

The LCD panel driving voltage is set by using JP6 jumper settings
illustrated as follows:
1
* Default

LCD Clock Signal Selection (JP7)

The LCD clock control signal is set by using JP7 jumper settings
illustrated as follows:
AShift Clock
1
* Default

Ethernet Tx/Rx/Link LED Connector (JP8)

With ethernet Tx/Rx/Link LED indicator, the ethernet status can be
trace up through LED indicator readings. The pin definitions are
listed as follows:
Pin
1
3
5
8 MB-668 Installation Guide
5V
2 3
2 3
Signal
Rx-LED
Link LED
Tx-LED
BC-599/596
* 3.3V
1 2 3
* Shift Clock
1 2 3
Pin Signal
2 Vcc
4 Vcc
6 Vcc