Table of Contents
Advertisement
15.
Power Sources – The appliance should be connected to a power supply only of
the type described in the operating instructions or as marked on the appliance.
Do not overload wall outlet.
16.
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
17.
Do not attempt to dismantle, open or repair this product yourself. If a fault occurs,
seek advice from your local qualified service technician or contact the distributor
via the telephone number at the back of this instruction manual.
18.
Caution marking and nameplate are located on back of product.
IMPORTANT NOTES
Avoid installing the unit in locations described below:
•
Places exposed to direct sunlight or close to heat radiating appliances such as
electric heaters.
•
Places subject to constant vibration.
•
Dusty, humid or moist places.
•
Sources of electrical noise such as fluorescent lamps or motors.
NOTE: when the system is switched to standby mode, it is still consuming some power.
To disconnect the system completely, switch the Power On/Off switch on the back of
the unit to OFF position. .
3
Advertisement
Table of Contents
