Step 2: Installing The Software - Microtek ArtixScanDI 8040c User Manual

Step 2: Installing the Software

Important: Do not remove the yellow stickers from your scanner until you are
told to do so. You must install all software before connecting your scanner.
Always close any open programs and turn off Anti-virus utilities before installing
software.
1. Turn on your computer.
2. Place the Microtek Software CD/DVD
3. Follow the on-screen instructions to
4. To install the software on the Microtek Software CD/DVD, click each software
5. Click EXIT on the Microtek Software Installer screen when all the software has
6. Restart your computer.
Drivers & Software Upgrades
After you finish the installation of software, if you found that the installed drivers and software
cannot run your product or your computer system properly later, please go to the Microtek
Download Service site at ww7.microtek.com.tw/service.php to download and install any updates
you may require.
For additional information about Microtek products, please visit our website at www.microtek.com.
12 ArtixScan DI 3020c / 8040c User's Manual
into a drive.
install the driver and software.
Note: If the Microtek Software
Installer screen does not come up
automatically, double-click the
following in succession: "My
Computer"; the CD/DVD-ROM icon;
then cdsetup.exe to start the installer
program.
program in the order that it appears on the screen to install, and follow the on-
screen instructions.
been installed.