Step 3. Installing The Software - Microtek ScanMaker i300 Install Manual

4 ScanMaker i300 Installing and Getting Started

Step 3. Installing the Software

For PC Users
1. Turn on your computer.
2. Place the Microtek CD-ROM into your CD-ROM drive. The Microtek Software
Installer screen should automatically come up.
Note: If the Microtek Software Installer screen does not come up automatically,
double-click the following in succession: "My Computer"; the CD-ROM icon;
and cdsetup.exe to start the installer program.
3. Click each software program in the order that it appears on the screen, and follow
the on-screen instructions to install. Do not turn off your computer during
software installation.
4. Click EXIT on the Microtek Software Installer screen when all the software has
been installed.
5. Install the image-editing software application, which is on a separate CD-ROM
included in your scanner package.
6. Restart your computer.
For Macintosh Users
1. Turn on your computer.
2. Install the image-editing software application, which is on a separate CD-ROM
included in your scanner package.
3. Place the Microtek CD-ROM into your CD-ROM drive and install all the software
components.
4. Restart your computer.
Note: After rebooting your computer (PC or Macintosh), the Microtek software will
attempt to locate your scanner on the system. Since this is your first install and you
have not yet connected the scanner, simply ignore the message that appears and
proceed to the next step.
Additional Documentation in the CD-ROM
Additional documentation is provided in the Microtek CD-ROM that contains ScanWizard 5, Step-by-
Step Tutorial, Microtek Scanner Configuration (MSC), troubleshooting, etc. If you experience problems
with hardware or software, you can open the file that you wish to view with Adobe Acrobat Reader or
your browser, then read or print the information.