On The Flatbed - Microtek ArtixScanDI 8040c User Manual

Note: There are several precautions and reminders about using the ADF correctly.
Please refer to the section as below for the detail.
•
•
•
•

On the Flatbed

This section shows you how to position a single-sheet document, such as a single
photograph or a page from a book, on the flatbed:
1. Raise the scanner lid, and place the document to be scanned face down on
2. Place the top end of the document towards the back of the scanner, then
16 ArtixScan DI 3020c / 8040c User's Manual
The document feeder is not designed for scanning photos; doing so may
damage your originals. Microtek accepts no responsibility for damage that
may arise from misuse of equipment.
The ADF can handle documents of the following sizes:
– Width: 3.15" to 8.5" (80 to 215.9 mm)
– Length: 3.15" to 25" (80 to 635 mm)
– Thickness: 10 to 30 lbs. (38 to 110 g/m
– Document Feed: 100 sheets maximum of copy bond paper
If the documents are torn, curled, or wrinkled, do not put them into the ADF
to scan, because they may cause paper jams.
Remove paper clips or staples before placing documents into the ADF. DO
NOT use the ADF to scan documents with paper clips or staples because they
may cause paper jams or damage the scanner.
the scanner glass surface.
lower the scanner lid on the scanner glass surface.
)
2
When scanning, the rear glass
surface should be kept clear and
free of obstruction at all times.
With the document face down on
the scanning glass, align the
document against the Horizontal
Ruler of the scanner.