STIHL HT 56, HT 70, HT 75,
–
HT 100, HT 101, HT 130, HT 131,
HT 250
STIHL KW 85
–
WARNING
The attachment is not approved for use
on bike-handled machines.
The optional 30° angle drive must not be
mounted to the following models:
STIHL HT 75, HT 101, models with
–
short drive tube (K versions).
WARNING
Combinations with basic power tools
other than those listed above are not
permitted since they may result in
accidents or serious personal injury.
HT
Mounting the Attachment
Preparations for Mounting the
Attachment
WARNING
To reduce the risk of injury, always shut
off the engine before converting the
basic power tool.
NOTICE
Make sure the work area is clean before
mounting or removing the attachment.
Rest the power tool on the machine
N
support.
Removing the protective cap
If a cap is fitted on the end of the power
tool's drive tube:
Pull the protective cap off the end of
N
the drive tube and keep it in a safe
place.
If the plug comes out of the drive tube
when you pull off the cap:
Push the plug into the drive tube as
N
far as stop.
Removing the gearbox or attachment
Remove any existing gearbox or
interchangeable attachment from the
basic power tool.
BF
FCS
English
13