Approved Basic Power Tools - Stihl HT Instruction Manual

English
Cutting above obstacles
The unit's long reach makes it possible
to prune branches that are overhanging
obstacles, such as rivers or lakes. The
tool angle in this case depends on the
position of the branch.
Cutting from a lift bucket
The unit's long reach enables cutting to
be performed next to the trunk without
the risk of the lift bucket damaging other
branches. The tool angle in this case
depends on the position of the branch.
12
30° angle drive (special accessory)
1
2
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1 For cross-cutting vertical branches
and bushes.
2 For a better view of the cutting
attachment.

Approved Basic Power Tools

WARNING
This interchangeable attachment is only
approved for use on a basic power tool
equipped with one of the following
handle systems:
1
1
2
Loop handle (1).
–
Handle hose (2).
–
Operation of this interchangeable
attachment is permitted only with the
following basic power tools:
1) 2)
STIHL FS 85 R , FS 90 R,
–
2)
FS 110 R , FS 130 R
STIHL FH 75
–
STIHL FC 85, FC 95, FC 110
–
STIHL HL 75, HL 100, the HT
–
attachment is not approved for
models with a short drive tube.
1)
Not approved for model FS 85 R
with serial numbers from
2 49 848 196 up to 2 53 552 820
2)
Not approved for models FS 85 RX
and FS 110 RX
HT