Cutting Attachment - Stihl HT Instruction Manual

3
1
3
Insert the clamp screws (3) as far as
N
stop.
Line up the gearbox (1) on the drive
N
tube so that the machine support on
the engine and the clamp screws
face up and the chain sprocket
cover is exactly vertical.
Tighten down the clamp screws (3)
N
in the following sequence:
tighten the left screw moderately
–
tighten the right screw moderately
–
tighten down the left screw firmly
–
tighten down the right screw firmly
–
WARNING
It must not be possible to rotate the
gearbox on the drive tube.
Fitting the Carrying Ring
A carrying ring is necessary if the power
tool is to be used with a shoulder
strap/harness. Not all versions of basic
power tools are equipped with a carrying
ring.
The carrying ring is available as a
special accessory and is mounted as
described below.
HT
2
A
2
3
Mount the carrying ring (1) at
N
distance A = about 5 cm (2 in) from
the control handle (2).
Place the open carrying ring (1)
N
against the drive tube with the
tapped hole on the left (viewed from
engine).
Squeeze the ends of the carrying
N
ring together and insert the M6x14
screw (3).
Line up the carrying ring and tighten
N
down the screw firmly.

Cutting Attachment

A cutting attachment consists of the saw
1
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
1
1
The pitch (t) of the saw chain (1),
–
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
–
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
English
2
3
a
15