Programmable Features - Directed Electronics Avital Maxx3 Installation Manual

Programmable Features

All system features and remote control features are accomplished by entering your Personal Identification Number
(PIN) by following steps 1-12 on page 18, then pressing the Valet switch a preset number of times to access the
feature you wish to program.
The system also allows you to add new remote controls in one step and delete lost or stolen remote controls.
1. Programming cannot be accessed while the system is in Valet mode indicated by the LED permanently lit.
Remove the system from Valet mode by turning on the ignition. The LED should turn off automatically.
2. Select the feature you wish to program from the Programming Table for System Features or the Programming
Table for Remote Controls sections of this guide. Note the number of chirps associated with that feature.
3. Follow steps 1-12 in the Entering Your Pin section of this guide.
4. Begin to press and release the Valet switch. The siren will chirp once each time you press and release the
Valet switch.
5. Continue pressing and releasing the Valet switch, counting the siren chirps.
NOTE: Stop when you reach the number of chirps associated with your chosen feature. The system
LED will give confirmation of the feature status. If the LED is ON, the feature is ON. If the LED is
OFF, the feature is OFF.
6. Follow the "Secondary Action" listed in the programming table. You will hear one or two chips and the system
LED will give you confirmation that you have changed the feature.
7. After you have programmed the feature you have chosen, you can exit programming by turning the ignition
key OFF. You will hear two chirps to confirm exit of program mode. If you wish to program additional fea-
tures, leave the ignition ON and press the Valet switch again. The system will advance to the next feature.
Continue pressing and releasing the Valet switch until you have reached your next chosen feature.
©
2002 Directed Electronics, Inc.
19