Final Testing Checklist; Certificate Of Installation - Directed Electronics Avital Maxx3 Installation Manual

Final Testing Checklist

I In the "Recommended Procedures" section on page 3, you removed the interior light fuse. You must now
replace it, shut the vehicles doors, boot and bonnet and arm the alarm by pressing the
cated by LED double flash sequence). If you connected the alarm to the vehicles central locking the doors
should lock, the siren should chirp twice and the indicators should flash twice.
I Unlock and open a door. The alarm should sound and indicators should flash. Press the
the siren. Follow this procedure for every trigger point (all doors, boot/tailgate and bonnet). When all trigger
points have been tested disarm the alarm fully by pressing the
I Open a window. Arm the alarm system, wait at least 20 seconds and then reach inside the car to trigger the
Ultrasonic sensors. The alarm should sound. Press the
on. Again, the alarm should sound. Fully disarm the system.
I Wait 30 seconds for the LED to flash slowly (Passive Auto Immobilisation). Try to start the car. The car should
not start. With the ignition ON press the
I Test the Valet PIN code is working by entering Valet mode. Turn the ignition on. The LED should turn off and
the system will exit Valet mode automatically.
I Test the remote control range. Stand approximately 50 feet from the car and press the
The alarm should arm/disarm.

Certificate of Installation

After Installation and testing you must fill out the certificate of installation. Once you have filled out all infor-
mation on the certificate the customer must sign and date it. Distribute the copies as follows:
White (top) copy - Customer
Blue copy - Customer's insurance broker
Pink copy - Directed Electronics UK Office
Green Copy - Installing Dealer
22
or
button to reset the siren and turn the ignition
button. Try to start the car. It should start.
button (indi-
button to reset
button twice.
or
©
2002 Directed Electronics, Inc.
button.