Table of Contents
Advertisement
Important Information
IMPORTANT! The Avital Maxx 3 system is designed to be installed in any petrol powered vehicle with
a 12 volt battery.
system components
One Avital Maxx 3 Control Unit with Metal Enclosure
One Prewired 18-Pin Connector Harness
One Prewired 10-Pin Connector Harness
One Prewired 4-Pin Pigtail Connector Harness
One Prewired Valet Switch
One Prewired Status LED
One 4-Button 10-Channel Remote Control
One 2-Button 3-Channel Remote Control
Two Ultrasonic Transducers
One Battery Back-up Siren with Mounting Bracket
One Hardware Pack
One Owner's Guide
One Certificate of Installation
Two Avital Window Decals
recommended procedures
1. Test all circuits with a voltmeter.
2. Make all wiring connections using solder and heatshrink using the procedure below. Do NOT twist wires or
use scotch-lock connectors.
•
Strip half an inch of insulation from the wires you are going to solder and slide a piece of shrink tubing
over one of them.
•
Join the wires together, then heat the wires with a soldering iron whilst touching solder to the wires
until the solder melts.
•
Pull the wires to test the solder joint, then position the loose shrink tube over the solder joint and gently
heat with a hot air gun so that it tightly seals and insulates.
3. Keep extensions as short as possible. Use the same gauge wires for short extensions and larger gauge wires
for longer extensions.
4. Before installing, discuss the placement of the LED indicator and Valet switch with the vehicle's owner.
5. Turn off interior light(s) or remove interior light fuse to prevent battery drain.
©
2002 Directed Electronics, Inc.
required installation tools
Voltmeter
Wire Strippers/cutters
Electric Drill & Bits
Phillips Screwdriver
Convoluted Tubing *
Soldering Iron
Wire Crimpers
Shrink Tube or Electrical Tape
* Optional
3
Advertisement
Table of Contents
