4-Pin Pigtail Connector (P3) - Directed Electronics Avital Maxx3 Installation Manual

4-Pin Pigtail Connector (P3)

Pin Number Wire Colour
1 BLACK with WHITE TAG No. 1
2 BLACK with WHITE TAG No. 2
3 BLACK with WHITE TAG No. 3
4 BLACK with WHITE TAG No. 4
NOTE: The current rating for each of the two onboard immobilisation circuits is 20 amps continu-
ous/30 amps peak.
Immobilisation Connections
Make sure the four black pigtail connector wires are solidly connected. The ignition and starter circuit may draw
very high current.
Ignition Disable
1. Locate the ignition switch loom under the dashboard.
2. Use a voltmeter to locate the one wire that shows 12 volts when the ignition key is in the ON, CRANK, and
RUN positions and 0 volts when the ignition key is in the OFF position.
3. Cut this wire in half. Test by attempting to start the engine with the ignition key. The starter should crank
but the engine should not start.
4. Connect the control unit BLACK wire marked 1 to the vehicle ignition switch side.
5. Connect the control unit BLACK wire marked 2 to the vehicle coil side.
NOTE: Remove all tags from wires after connection.
Starter Disable
1. Locate the ignition switch wireloom under the dashboard.
2. Use a voltmeter to find the one wire that will show 12 volts while the ignition key is in the CRANK position
only. This should be the starter solenoid wire.
3. Cut the starter solenoid wire. Test by trying to crank the starter with the ignition key. If it does not crank,
you have the correct wire.
4. Connect the control unit BLACK wire marked 3 to the key side.
5. Connect the control unit BLACK wire marked 4 to the starter side.
NOTE: Remove all tags from wires after connection.
10
Description
Immobiliser Circuit No.1
Immobiliser Circuit No.1
Immobiliser Circuit No.2
Immobiliser Circuit No.2
©
2002 Directed Electronics, Inc.