Final Wiring Connections; System Status/Diagnostic Charts; Led System Status Indicator; Specific Zone Intrusion Identification - Directed Electronics Avital Maxx3 Installation Manual

Final Wiring Connections

1. Inspect all alarm wiring. Make sure all wires are connected.
2. Install the 5 amp fuse in the BLACK wire with RED tag fuse assembly.
3. Install the 20 amp fuse in the BLACK wire with WHITE tag fuse assembly (if the vehicle indicator lights are
positive).
NOTE: Remove tags from wires after connection.

System Status/Diagnostic Charts

LED System Status Indicator

LED
Off
On
Slow Flash
Double Flash
Triple Flash
Flashing in Cycles
Rapid Flash

Specific Zone Intrusion Identification

If the alarm has been triggered, the siren will chirp three times upon remote disarm. Turn the ignition ON and
count the LED flashes. Each flash cycle is repeated two more times giving three cycles in total.
LED
Three Flashes
Four Flashes
Five Flashes
Six Flashes
Seven Flashes
Eight Flashes
©
2002 Directed Electronics, Inc.
Zone
Optional Sensor 2
Door Trigger Input (-)
Boot/Bonnet Trigger
Normally Closed Trigger Input (-)
Ultrasonic Sensor
Ignition Trigger
Status
System is disarmed.
In Valet mode.
Passive Immobilised only.
System is armed and Immobilised.
More than three consecutive incorrect Valet
codes have been entered (system ignores
Valet switch for two minutes).
See "Specific Zone Intrusion Identification"
chart below.
Passive arming countdown.
Input Description
Dual Zone 4-pin
P2 Pin 8 GREEN
P2 Pin 2 BLUE/WHITE or Pin 7 BLUE
P2 Pin 4 BLACK/WHITE
P1 Pin7/8/9 Ultrasonic sensors
P2 Pin 3 BLACK with ORANGE Tab
11