Operating Procedure To Receive - AnyTone AT-5555 User Manual

50ms.
Default: 500ms
CFR (CW Side Tone Frequency)
This menu is to select CW Side Tone Frequency from 300HZ 3KHZ, the shift step is
10HZ.
Default: 1050HZ
TON (Transmitting Single-Tone Frequency)
This menu is to select Transmitting Single-Tone Frequency from 300HZ-3KHZ. The shift
step is 10HZ.
Default: 1050HZ

OPERATING PROCEDURE TO RECEIVE

1. Be sure that power supply, microphone and antenna are connected to the proper
connectors before going to the next step.
2. Turn the radio on by tuning VOLUME control clockwise
3. Rotate the VOLUME knob to set a comfortable listening level
4. SET the MODE switch to the desired mode.
5. Set the CHANNEL selector switch to select the desired channel.
6. Set the RF gain control full clockwise to maximum RF gain
7. Listen to the background noise from the speaker. Turn the SQUELCH control
clockwise slowly until the noise disappears (no signal should be present). Leave the
control at this setting. The Squelch is now properly adjusted. The receiver will remain
quiet until a signal is actually received. Do not advance the control too far, or some of
the weaker signals can not be heard.