Voice Recognition Function - Mitsubishi LANCER Owner's Manual

Features and controls
NOTE
When you press the SPEECH button to enter voice recog-
nition mode with a cellular phone paired to the system,
current information on the cellular phone, such as
"remaining battery life," "signal strength" or "roaming,"
will be displayed on the audio display.* (Refer to "Pairing
a cellular phone" on page 3-246.)
*: Some cellular phones will not send this information to
the Hands-free Bluetooth
tem with voice recognition.
Call waiting and three-way calls can be used by the
Hands-free Bluetooth
with voice recognition, only when those services can be
3
used with your cellular phone.
3-240
®
cellular phone interface sys-
®
cellular phone interface system

Voice recognition function

®
The Hands-free Bluetooth
with voice recognition is equipped with a voice recognition
function. Your voice will be recognized by a microphone in the
dome light (front), allowing you to make hands-free calls with
voice commands.
Voice recognition is possible in US English, North American
Spanish and Canadian French. The factory setting is US
English.
Some of the voice commands indicated below have a number
of alternative commands. For a table showing the voice com-
mands in each language and the corresponding alternative
commands, refer to "Commands and Alternatives" on page 3-
260.
NOTE
If the voice command that you say differs from the pre-
defined command or cannot be recognized due to ambient
noise or some other reason, the Hands-free Bluetooth
cellular phone interface system with voice recognition
will ask you for the voice command again up to 3 times.
For best performance and further reduction of ambient
noise, the vehicle windows should be closed while engag-
ing the voice recognition function.
Selecting the Language
There are two ways to change the language.
NOTE
The more entries that are registered in the phonebook, the
longer it will take to change the language.
N00506600104
cellular phone interface system
®