Digital Clock - Mitsubishi LANCER Owner's Manual

Comfort controls

Digital clock

The time is displayed when the ignition switch is in the "ON"
or "ACC" position.
To set the time
CLOCK DISP
5
1. Press and hold the CLOCK button and the clock display
flashes.
2. Press the various buttons to adjust.
H — "Hour" setting
Press this button to fast-forward the "hours".
M — "Minutes" setting
Press this button to fast-forward the "minutes".
5-124
N00755000065
H M :00
:00 — Time signal setting
At the same time the button is pressed, the fol-
lowing modifications are made.
10:00 - 10:29 ......Change to 10:00
10:30 - 10:59 ......Change to 11:00
3. When the time is set, press the DISP button to stop the
clock display from flashing. After time signal setting,
however, the clock display automatically stops flashing.
NOTE
Reset the time after the battery terminals are disconnected
and reconnected.
Seconds do not appear in the clock display, but after
adjusting the "Minutes" setting and time signal setting,
the clock begins to operate from 0 seconds.