Table of Contents
Advertisement
GS-R113-RH Series Rack Mount Server
Step 2-5: PCI Expansion Card Installation
GS-R113-RH Series provides expansion riser slots for one PCI 32/33MHz slot and one PCI-E x8
slot. To install the peripheral, please go through the following steps.
Note!! Before installing the PCI expansion card, please check the card size limitation. Size limitation
for PCI-X full-height/full-length is 228.5 mm x 91.5 mm; size limitation for Low-Profile Card : 167.5 mm
x 56 mm .
Step 1 Loosen the riser bracket screws.
Step 2 Lift the riser bracket slightly, then pull it out from the server chassis.
Step 3 Unlock the screw on the riser bracket to remove the PCI bracket. Align the expansion card
with the guiding groove. Slide the expansion card into the slot until the card firmly seats.
Step 4 Align the riser bracket to the system module (see the arrow direction mark 1), and push
it to locked position.
Step 5 Reverse Step 1 & 2 to lock the riser bracket firmly. Installation completed.
Step 1
Step 3
Step 2
Step 4
1 4
Advertisement
Table of Contents
