Table of Contents
Advertisement
mode depending on the setting of feature #73
(page 66).
L You cannot return to TAM/FAX mode in the
same call.
To turn ON the auto answer setting
1. Call your unit and wait for 20 rings.
L A beep will sound.
2. Enter the remote operation ID (feature #11 on
page 63) within 8 seconds.
L The auto answer setting will be turned
ON. The receiving mode will be set to
TAM/FAX or FAX ONLY mode, depending
on the setting of feature #77 (page 67).
3. Hang up the handset.
Note:
L You cannot turn ON the auto answer setting
in the following cases:
– when the unit is set to TEL/FAX mode.
– when the unit is set to TEL mode and
night mode (feature #35 on page 33) is
turned ON.
Recording a marker message
After playing back the messages, you can leave
an additional message.
1. Wait about 10 seconds.
2. Leave a message after the beep.
Note:
L If you do not enter a remote command key
within 10 seconds after the last operation, the
unit will ask you to leave a marker message.
8.5 Pager call
This feature allows your unit to call your pager
when your unit receives an incoming voice
message.
{SP-PHONE}
1
Press {MENU}.
2
Press {#}, then {7}{0}.
3
Press {A} or {B} repeatedly to select "ON".
{SET}
{A}{B}
{MENU}
8. Answering Machine
4
Press {SET}.
5
Enter your pager number and/or pauses (up
to 46 digits).
Example:
1 202 555 1234PP12345678PP5555#
– 1 202 555 1234: Your pager number
– PP: Pauses
– 12345678: Your pager access code, if
required.
– 5555 (example): Message you want
displayed on your pager.
6
Press {SET}.
L The unit will dial the stored number.
7
Check that your pager received the pager
test call.
8
Press {SP-PHONE}, or wait for 10 seconds.
When your pager receives a pager call
Your pager will display the message you entered
in step 5 (for example:5555).
61
Advertisement
Table of Contents
