Table of Contents
Advertisement
2. Select "Answer System", then press {>}.
3. Select "Settings", then press {>}.
4. Select "Number of Rings", then press
{>}.
5. Select the desired setting, then press {>}.
6. Press {ih}.
Note:
L You can also program this feature with the
base unit (feature #06 on page 63).
For voice mail service users
To receive voice mail and use answering system
properly, please note the following:
– To use the voice mail service provided by
your service provider rather than this unit's
answering system, turn off the answering
system (page 49).
– To use this unit's answering system rather
than the voice mail service provided by your
service provider, please consult your service
provider to deactivate your voice mail
service.
If your service provider cannot do this, set
this unit's "Number of Rings" setting so
that this unit's answering system answers
calls before the service provider's voice mail
service tries to answer your calls. It is
necessary to check the number of rings
required to activate the voice mail service
provided by your service provider before
changing this setting.
Selecting the caller's recording time
You can change the maximum message
recording time allotted to each caller, or set the
unit to greet callers but not record messages.
1. Press {j/OK}.
2. Select "Answer System", then press {>}.
3. Select "Settings", then press {>}.
4. Select "Recording Time", then press {>}.
5. Select the desired setting, then press {>}.
6. Press {ih}.
Note:
L You can also program this feature with the
base unit (feature #10 on page 63).
Turning call screening on/off
While a caller is leaving a message, you can
screen the call through the cordless handset
speaker.
1. Press {j/OK}.
2. Select "Answer System", then press {>}.
8. Answering Machine
3. Select "Settings", then press {>}.
4. Select "Call Screening", then press {>}.
5. Select "On" or "Off", then press {>}.
6. Press {ih}.
Note:
L You can also program this feature with the
base unit (feature #67 on page 66).
Turning message alert on/off
This feature alerts you when new messages
have been recorded. The base unit beeps slowly
until you have listened to all new messages.
1. Press {j/OK}.
2. Select "Answer System", then press {>}.
3. Select "Settings", then press {>}.
4. Select "New Msg. Alert", then press {>}.
5. Select "On" or "Off", then press {>}.
6. Press {ih}.
Note:
L You can also program this feature with the
base unit (feature #42 on page 65).
59
Advertisement
Table of Contents
