Table of Contents
Advertisement
3.6 Adjusting base unit
volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display "RINGER
OFF= OK?".
2. Press {SET}.
L When a call is received, the base unit will not
ring for outside calls and will display
"INCOMING CALL". The base unit will ring at
the low level for intercom calls.
L To turn the ringer back ON, press {A}.
Ringer type
L You can select the ringer types from one of 6
types for outside calls (feature #17 on page
63).
Handset receiver volume
While using the handset, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or
{B}.
Answering machine volume
While listening to messages, press {A} or
{B}.
{SET}
{A}{B}
Initial Programming
3.7 Dialling mode
If you cannot dial (page 24, 40), change this
setting depending on your telephone line
service.
3.7.1 With the cordless handset
{j/OK}
{>}
1
Press {j/OK}.
2
Select "Base Unit Setup", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page 76).
4
Select "Call Options", then press {>}.
5
Select "Dial Mode", then press {>}.
6
Select the desired setting, then press {>}.
– "Tone" (default): For tone dial service.
– "Pulse": For rotary pulse dial service.
7
Press {ih}.
3.7.2 With the base unit
{A}{B}{<}{>}
1
Press {MENU}.
2
Press {<} or {>} repeatedly to display the
following.
3. Preparation
{ih}
{SET}
{MENU}
SYSTEM SETUP
PRESS [( )]
DIALLING MODE
=TONE
[±]
19
Advertisement
Table of Contents
