Pager Call - Panasonic KX-FT932FX Operating Instructions Manual

Turning pager call ON or OFF
You must program a pager number beforehand (feature
#70, page 31).
Press {8}{3} to turn ON the pager call.
Press {8}{4} to turn OFF the pager call.
L If a pager number is not programmed, you cannot
turn this feature ON. 6 beeps will sound.
Recording a marker message
After playing back the messages, you can leave an
additional message.
1. Wait for 3 beeps indicating the end of the remote
operation.
2. Hear 1 beep.
3. Wait about 10 seconds.
4. Hear the voice guide and hear 1 beep.
5. Leave a message.
Setting to TAM/FAX mode from TEL mode
1. Call your unit and wait for 10 rings.
L The answering device will temporarily answer the
call.
2. Enter the remote operation ID during the greeting
message.
L A long beep will sound, and your unit will switch to
TAM/FAX mode.
3. Hang up the handset.

7.5 Pager call

This feature allows your unit to call your pager when your
unit receives an incoming voice message.
{SP-PHONE}
1
Press {MENU}.
2
Press {#}, then {7}{0}.
3
Press {A} or {B} repeatedly to select "ON".
4
Press {SET}.
5
Enter your pager number and/or pauses (up to 46
digits).
Example:
1 202 555 1234PP12345678PP5555#
– 1 202 555 1234: Your pager number
– PP: Pauses
{SET}
{A}{B} {MENU}
7. Answering Machine (KX-FT938 only)
– 12345678: Your pager access code, if required.
– 5555 (example): Message you want displayed
on your pager.
6
Press {SET}.
L The unit will dial the stored number.
7
Check that your pager received the pager test call.
8
Press {SP-PHONE}, or wait for 10 seconds (pager
only).
When your pager receives a pager call
Your pager will display the message you entered in step
5 (for example:5555).
31