Table of Contents
Advertisement
10. Multi-unit Operation
6
Wait until "Enter Base PIN" is displayed,
then enter "0000" (default base unit PIN),
then press {j/OK}.
L If you changed the PIN, enter it (page 76).
L When the cordless handset has been
registered successfully, w will stop
flashing. If key tones are turned ON (page
73), a confirmation tone will be heard.
10.2.1 Selecting a base unit
When "Auto" is selected, the cordless handset
will automatically use any available base unit it is
registered to. When a specific base unit is
selected, the cordless handset will make and
receive calls using that base unit only. If the
cordless handset is out of range of that base
unit, no calls can be made or received.
1
Press {j/OK}.
2
Select "Handset Setup", then press {>}.
3
Select "Select Base", then press {>}.
4
Select the desired base unit number, or
"Auto", then press {>}.
L The cordless handset starts searching for
the base unit.
10.2.2 Cancelling a cordless
handset
A cordless handset can cancel its own
registration (or the registration of another
cordless handset) that is stored in the base unit.
This will allow the base unit to forget the cordless
handset.
1
Press {j/OK}.
2
Select "Base Unit Setup", then press
{>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page 76).
4
Enter "335".
5
Select "Cancel Handset", then press
{>}.
L The numbers of all cordless handsets
registered to the base unit are displayed.
6
Select the cordless handset(s) you want to
cancel, by pressing the desired cordless
handset number.
L The selected cordless handset
number(s) will flash.
L To cancel a selected cordless handset
number, press the number again. The
number will stop flashing.
78
7
Press {j/OK}.
8
Select "Yes", then press {>}.
10.2.3 Cancelling a base unit
A cordless handset can cancel a base unit that it
is registered to. This allows the cordless handset
to forget the base unit.
1
Press {j/OK}.
2
Select "Handset Setup", then press {>}.
3
Select "Registration", then press {>}.
4
Enter "335".
5
Select "Cancel Base", then press {>}.
6
Enter "0000" (default cordless handset
PIN).
L If you changed the PIN, enter it (page 73).
7
Select the base unit(s) you want to cancel, by
pressing the desired base unit number.
L The selected base unit number(s) will
flash.
L To cancel a selected base unit number,
press the number again. The number will
stop flashing.
8
Press {j/OK}.
9
Select "Yes", then press {>}.
10
Press {ih}.
Note:
L To register the cordless handset to another
base unit or to the same base unit again, see
page 77.
10.2.4 Increasing the range of
the base unit
You can increase the range of the base unit by
using a DECT repeater. Please use only
Panasonic DECT repeater. See page 5 for
accessory information.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode ON.
Setting the repeater mode
1. Press {j/OK}.
2. Select "Base Unit Setup", then press
{>}.
3. Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page 76).
4. Select "Other Options", then press {>}.
Advertisement
Table of Contents
