Storage - Gardena 2403 Operating Instructions Manual

O
G
z
3a
Q
Fault
The Turbotrimmer
no longer cuts.
If you have any other problems please contact the GARDENA Customer Service.

7. Storage

Storage :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
3
5. Unwind the filament
the lower filament) approximately 10 cm
and thread it through the eye
plastic ring
filament beforehand using a screwdriver.
The filament
over the knife
6. Only for classicCut plus : unwind the
upper filament
R N
and fit it into the notch
cassette.
7. Pull the plastic ring
(with classicCut plus ensure that the upper filament
in the slot
8. Reinstall the filament cassette as described under 5. Mainte-
nance "Replacing the filament cassette".
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
Possible cause
Filament worn or too short.
Filament cassette empty.
Filament drawn into the
cassette or stuck together.
The Turbotrimmer must be stored out of the reach of children.
v Store your Turbotrimmer in a dry place where it is protected
from frost.
Recommended storage :
We recommend that you hang your Turbotrimmer from the cable
lock. Hanging storage helps avoid unnecessary stress on the
cutting head.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
3
(with classicCut plus
O
of the
N
. If necessary, loosen the
3
may stand out max. 2 cm
P
.
3
a approximately 10 cm
Q
of the filament
N
back over the filament cassette
R
of the plastic ring).
Remedy
v Lengthen the filament –
v Replace the filament cassette
v Pull the filament out of the
G
3
a is
see 4. Operation "Filament
feed (Tip mechanism for
automatic filament feed )".
– see 5. Maintenance
"Replacing the filament
cassette" ).
filament cassette (see above).
P
15