Trouble-Shooting - Gardena 2403 Operating Instructions Manual

Replacing the filament
cassette :
J
K
G
3
M
L

6. Trouble-Shooting

Risk of injury !
Pulling the filament
out of the filament cassette :
G
N
14
Risk of injury !
A
V Never use metallic cutting elements or replacement
parts and accessories not provided by GARDENA.
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
K • Filament Cassette for Turbotrimmer classicCut :
Art. No. 5365-20 (one filament)
• Filament Cassette for Turbotrimmer classicCut plus :
Art. No. 5366-20 (two filaments)
3
1. Unplug the mains plug.
N
2. Turn over the Turbotrimmer and rest it on the rubber buffer
of the handle.
M
3. Release the cassette cover
K
0clips and remove the cover.
4. Remove the filament cassette
5. Remove any dirt.
6. Pull approximately 5 cm of the filaments
the classicCut) out of the new filament cassette
the hole in the plastic ring
7. Insert the filament cassette
so that the filaments
8. Fit the cassette cover
that you hear both locking clips
When replacing the cover, ensure that the filaments are inside
the metal cases and are not trapped.
v If the cassette cover
filament cassette
is completely in the filament cassette holder
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
If a filament is drawn into the filament cassette you can pull it out
again as described below.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 5. Mainte-
nance "Replacing the filament cassette".
3. Press together the plastic ring
between your thumb and forefinger.
4. Draw the plastic ring
the side part of the filament cassette
necessary).
You can now access the filament that was drawn into the
filament cassette.
J
by pressing both locking
G
.
3
N
.
G
in the filament cassette holder
3
are inside the metal cases
J
on the filament cassette holder
K
click into place.
J
cannot be touched down, turn the
G
to and fro, until the filament cassette
N
on the filament cassette
N
with the thumb of the other hand over
G
(use a screwdriver if
(one filament for
G
through
L
M
.
L
so
G
L
.
G