Maintenance - Gardena 2403 Operating Instructions Manual

Starting your Turbotrimmer :
8
F
Trimming along lawn edges
and in awkward places :
A
B
Filament feed (Tip mechanism
for automatic filament feed) :
G
2
G

5. Maintenance

Risk of injury !
Risk of injury !
Cleaning the cover
and ventilation slots :
1. Press the start button
The Turbotrimmer starts.
2. Release the start button
The Turbotrimmer switches off.
1. For vertical cutting, loosen the tightening
B
nut , turn the additional handle
and then tighten the nut
2. Swivel the plant guard
the park position until it clicks into place.
3. Lift the Turbotrimmer by the handle
and additional handle
cutting position.
8
4. When trimming between paving stones,
hold the Turbotrimmer so that the cutting
filament moves slightly above the paved
ground.
The filament is lengthened automatically when the motor is
running using a tip mechanism. A clean cut is only achieved
with the maximum filament length.
H
1. Leave the motor running.
2. Hold the cutting head
ment cassette
times in succession (approx. 3 times) (avoid applying sustained
pressure to the Turbotrimmer).
The filament is lengthened automatically. Listen for the audible
switching action. The filament limiter
the correct length.
There is a risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer be-
fore carrying out maintenance work !
Risk of injury and risk of damage to property !
V Never clean the Turbotrimmer under running water or
with a water jet (in particular a high pressure water jet).
The ventilation slots must always be free of dirt.
v Remove any grass and dirt from the
1
cover and ventilation slots
each use.
F
on the handle
F
on the handle
A
180 °
B
again by hand.
5
backwards to
8
A
and turn to the
2
parallel to the ground and tap the fila-
G
of the Turbotrimmer on the ground several
H
adjusts the filament to
I
after
8
.
8
.
5
Cutting position
5
Park position
I
1
13