Replacing The Internal Drive-Bay Bracket - IBM IntelliStation M Pro User Manual

Replacing the internal drive-bay bracket

To install the internal drive-bay bracket, complete the following steps:
1. Place the top edge of the drive-bay bracket into place on the chassis. Rotate
2. Install the two screws that fasten the top edge of the drive-bay bracket to the
3. If you removed the hard disk drive while removing the drive-bay bracket, install
4. Reconnect the signal and power cables to the hard disk drive in the
5. Replace the side cover (see "Replacing the side cover" on page 67).
6. Reconnect the external cables and power cords.
7. Turn on the attached devices, and turn on the computer.
the drive-bay bracket downward until it engages in the chassis.
chassis.
the hard disk drive now (see "Installing an Ultra320 SCSI, SATA, or SAS drive in
bay 5" on page 59).
drive-bay bracket.
Screws
Alignment tabs
Chapter 4. Installing options
65