IBM IntelliStation M Pro User Manual page 67

10. Install the blue drive retainer clip into the screw holes on the side of the drive
(with the blue side of the clip facing outward).
Drive retainer clip
11. Slide the drive into the front of the bay until it snaps in place.
12. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor.
13. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
14. Replace the internal drive-bay bracket (see "Replacing the internal drive-bay
bracket" on page 65).
15. Replace the bezel (see "Replacing the bezel" on page 66).
16. Replace the side cover (see"Replacing the side cover" on page 67).
17. Reconnect the external cables and power cords.
18. Turn on the attached devices and the computer.
Installing an optional diskette drive in bay 3
To install a drive in bay 3, complete the following steps:
1. Read the safety information that begins on page vii, the Installation guidelines
on page 35, and the documentation that comes with the drive.
2. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
3. Remove the side cover (see "Removing the side cover" on page 41).
4. Remove the bezel (see "Removing the bezel" on page 42).
5. Remove the internal drive-bay bracket (see "Removing the internal drive-bay
bracket" on page 43).
Chapter 4. Installing options
53