Replacing the internal drive-bay bracket
To install the internal drive-bay bracket, complete the following steps:
1. Place the top edge of the internal drive-bay bracket into place on the chassis.
2. Install the two screws that fasten the top edge of the drive-bay bracket to the
3. If you removed the hard disk drive while you removed the drive-bay bracket,
4. Reconnect the signal and power cables to the hard disk drive in the
54
IBM IntelliStation M Pro Type 9229: User's Guide
Rotate the drive-bay bracket downward until it engages in the chassis.
chassis.
install the hard disk drive now (see "Installing a drive in bay 4, 5, or 6" on page
47).
drive-bay bracket.
Release tab
Handle