Related Manuals for Herutu POKAYOKE TWF-600R
Summary of Contents for Herutu POKAYOKE TWF-600R
-
Page 1: Operation Manual
V20061020 POKAYOKE Receiver [ TWF-600R ] Operation Manual V 1.03 HERUTU ELECTRONICS CORPORATION 62-1 Toyooka, Hamamatsu, Shizuoka, 433-8103 Japan TEL. 81-53- 438-3555 FAX. 81-53- 438-3411... - Page 3 Safety concerns (Be sure to read) To prevent human injury of user or damage in property from occurring, be sure to observe the precautions shown below. ■ The degree in safety hazard and damage generated by the wrong usage while ignoring the descriptions is classified by the following displays.
- Page 4 Warning ！ ■For handling the power source: Be sure to observe the following precautions to prevent the AC adapter and Power cord from being heated, damaged, or ignited. ●Do not approximate the AC adapter and Power cord to a fire, or do not put them into a fire.
- Page 5 CAUTION CHANGE OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TOOPERATE THE EQUIPMENT TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THE FOLLOWNG APPLIES ONLY IN THE U.S.A This device complies with Part 15 of the FCC Rules.
-
Page 6: Table Of Contents
Contents １．Outline ............................1 ２．Specification ..........................2 ３．Each part name........................4 ４．Outline of operation ......................5 ４−１．Normal operation ......................5 ４−２．ID login ........................5 ４−３．Setting the contact output time .................6 ５．Installation method........................7 ６．Dimensional drawing ......................8 ７．Guarantee..........................9... -
Page 7: １．Outline
Outline １．Outline This machine receives the frame data transmitted from Transmitter provided with software which can communicate, and actuates the corresponding output during the preset time. The frame data transmitted from Transmitter contains ID codes equivalent to 16bit. From among 65536 type’s codes, two codes, which were previously logged in this machine, can be received. -
Page 8: ２．Specification
Specification ２．Specification General specification Items Specification Model TWF-600R FCC Part15B Appropriate IC RSS-210 standard/Regulation RoHS Destination US/Canada Operating power DC12V (Operative voltage zone: DC10 to 16V) voltage DC Jack Operating power Appropriate plug: Internal diameterφ2.1mm source External diameterφ5.5mm Center-minus Current consumption 150mA at max when DC12V is input Working °... - Page 9 Specification Specification of radio section Communication Unidirectional communication system system Electric wave type Modulation Binary FSK method Modulation rate 1000bps Receiver 426.1 MHz frequency Receiving circuit Double super heterodyne system system Receiving 0dBμVemf or less sensitivity Antenna Ω BNC-J Connector Nominal impedance 50 terminal...
-
Page 10: ３．Each Part Name
Each part name ３．Each part name ⑤Nameplate label affix ④ BNC Connector point for Antenna ①Receiving lamp 1 (ID LOGIN SWITCH 1) ②Receiving lamp 2 (ID LOGIN SWITCH 2) ③Output terminal block ⑧Antenna ⑥DC Jack DC12V for feeding ⑦Power switch operating power Items Contents... -
Page 11: ４．Outline Of Operation
Outline of operation ４．Outline of operation ４−１．Normal operation Once this machine receives two kinds of codes, namely, ID1 and ID2, which were previously logged in, the contact output of either output 1 or output 2 runs during the preset time just as Receiving lamp 1 or Receiving lamp 2 lights on depending on the received code. -
Page 12: ４−３．Setting The Contact Output Time
Outline of operation To clear the ID ① Turn on the Power switch while pushing the ID LOGIN SWITCH corresponding o the ID you need to login. ID1→Receiving lamp1 ID2→Receiving lamp2 (Receiving lamp can also be used as the ID LOGIN SWITCH) ②... -
Page 13: ５．Installation Method
Installation method ５．Installation method ① Install this machine in the place where it can be easily viewed from the Transmitter and also an electric wave can be stably received. ② Set the antenna so that it is not parallel to the metal plates and keep away it from metal plates as far as possible. -
Page 14: ６．Dimensional Drawing
Dimensional drawing ６．Dimensional drawing... -
Page 15: ７．Guarantee
Guarantee ７．Guarantee This product passed it by our close product inspection. When it broke down under the normal use of a visitor by any chance, we will repair a trouble point according to a rule, please report to a store of purchase. However we are limited to hardware of this product. In addition, we become charged repair in the case of next even if I put it before a term of a guarantee. - Page 16 ●If you have unclear points for the repair or after service during the guarantee period, consult the outlet store through which you purchased or our sales office. ● The contents in this manual are subject to change without prior notice. ●...
Need help?
Do you have a question about the POKAYOKE TWF-600R and is the answer not in the manual?
Questions and answers