Field Equipment Required; Additional Required Tools And Adhesives; Warning; Before Starting Assembly - Hangar 9 Twist 3D .40 ARF HAN2660 Assembly Manual

Field Equipment Required

• Propeller (2-stroke (EVO11050) 4-stroke (EVO13080))
• Fuel
• Glow Plug Wrench (HAN2510)
• 12-Volt Starter (HAN162)

Additional Required Tools and Adhesives

Tools:
• Canopy scissors
• Drill
• Drill bits: 1/16-inch, 3/32-inch, 1/8-inch, 9/64-inch, 5/32-inch
• Felt-tipped pen
• Flat blade screwdriver
• Foam: 1/2-inch
• Hobby knife
• Making tape
• Paper towels
• Petroleum jelly
• Phillips screwdriver (large)
• Phillips screwdriver (small)
• Pliers
• Rubbing alcohol
• Ruler
• Sandpaper
• Soldering iron
• Square
• T-pins

Warning

An RC aircraft is not a toy. If misused, it can cause serious bodily harm and damage to property. Fly only in open areas, perferably
at AMA (Academy of Model Aeronautics) approved flying sites, following all instructions included with your radio and engine.
Age Recommendation: 14 years or over. Not a toy. Not intended for use by children without direct adult supervision.
4
• Glow Plug Igniter with Charger (HAN7101)
• Glow Plug (EVOGP1/HAN3011)
• Manual Fuel Pump (HAN118)
Adhesives:
• 6-minute epoxy (PAAPT38)
• 30-minute epoxy (PAAPT39)
• Thin CA (PAAPT07)
• Medium CA (PAAPT01)
• CA remover/debonder (PAAPT16)
• Masking tape (MMM20901)
• Canopy glue (Formula 560)
Other Required Items:
• 2 ¼-inch spinner (Red, DUB280)
• Epoxy brushes (DUB345)
• File
• Measuring device (e.g. ruler, tape measure)
• Mixing sticks for epoxy (DUB346)
• Paper towels
• Rubbing alcohol
• Wax paper

Before Starting Assembly

Before beginning the assembly of your Twist, remove each part from its bag for inspection. Closely inspect the fuselage, wing
panels, rudder, and stabilizer for damage. If you find any damaged or missing parts, contact the place of purchase.
If you find any wrinkles in the covering, use a heat gun or covering iron to remove them. Use caution while working around areas
where the colors overlap to prevent separating the colors.
HAN100 – Heat Gun

Using the Manual

This manual is divided into sections to help make assembly easier to understand and to provide breaks between each major
section. In addition, check boxes have been placed next to each step to keep track of each step completed. Steps with two boxes
indicate the step will require repeating, such as for a right or left wing panel, two servos, etc. Remember to take your time and
follow the directions.
HAN135 – Pro-Seal
Covering Iron
5