Drive Cage Assembly - HP ProLiant DL320e Gen8 Maintenance And Service Manual

Disconnect the optical drive cable from the drive.
8.
To replace the component, reverse the removal procedure.

Drive cage assembly

The drive cage assembly includes the drive cage with backplane and the front panel assembly.
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove all drives
3.
Remove the server from the rack (on page 30).
4.
If the server is installed in a friction rail system, remove the friction rails from the chassis. For more
5.
information, see the documentation that ships with the rail system.
Remove the access panel
6.
Disconnect the front panel assembly cables from the system board.
7.
Disconnect all cables connected to the drive cage.
8.
Remove the optical drive
9.
("Hot-plug drive" on page 33,
("Access panel" on page 35).
("Optical drive" on page 36).
"Storage drive" on page 32).
Removal and replacement procedures 38