Hot-Plug Power Supply - HP ProLiant DL320e Gen8 Maintenance And Service Manual

Remove the power supply blank.
2.
To replace the component, reverse the removal procedure.

Hot-plug power supply

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Access the rear panel
3.
WARNING:
power supply blank to cool before touching it.
Remove the power supply.
4.
To prevent improper cooling and thermal damage, do not operate the server unless
("Access the product rear
To reduce the risk of personal injury from hot surfaces, allow the power supply or
panel" on page 29).
Removal and replacement procedures 34