IMPORTANT: The server does not power up if the PCI riser cage is not seated properly.
Connect and route all drive cables. For more information, see "Drive cabling (on page 67)."
10.
Install the server into the chassis
11.
Connect all peripheral cables to the server.
12.
Press the Power On/Standby button.
13.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.
Hot-plug drive cage assembly
To remove the component:
Back up all server data on the drive.
1.
Power down the server (on page 26).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page 27).
4.
Place the server on a flat, level work surface.
5.
Remove the PCIe riser board assembly
6.
Disconnect all cables from the drive cage backplane.
7.
12 GB backplane
o
("Install the
server" on page 29).
("PCIe riser board
assembly" on page 35).
Removal and replacement procedures 38