Disconnect all peripheral cables from the server.
2.
Remove the server (on page 14).
3.
Place the server on a flat, level work surface.
4.
IMPORTANT:
component, be sure to install the screws in the proper location. Failure to do so will cause the
server to not install properly into the chassis.
Using a T-10 Torx screwdriver, remove the PCI riser board assembly.
5.
Disconnect all cables connected to existing expansion boards.
6.
Remove the drive cage assembly
Back up all server data on the drive.
1.
Power down the server (on page 13).
2.
Disconnect all peripheral cables from the server.
3.
Remove the server (on page 14).
4.
Place the server on a flat, level work surface.
5.
Remove the PCI riser board assembly (on page 15).
6.
Both T-10 and T-15 screws are required for this procedure. When replacing the
Operations 16