For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Non-hot-plug power supply
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Remove the air baffle
5.
WARNING:
power supply blank to cool before touching it.
Disconnect all drive power cables and the non-hot-plug power supply cables.
6.
Remove the power supply.
7.
To replace the component, reverse the removal procedure.
Non-hot-plug power supply bracket
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
("Access
panel" on page 35).
("Air
baffle" on page 35).
To reduce the risk of personal injury from hot surfaces, allow the power supply or
Removal and replacement procedures 57