Fan Module - HP ProLiant DL320e Gen8 Maintenance And Service Manual

Remove the drive cage assembly.
10.
To replace the component, reverse the removal procedure.

Fan module

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 28).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
Remove the air baffle
5.
Disconnect the fan cable from the system board.
6.
To prevent improper cooling and thermal damage, do not operate the server unless
("Access panel" on page 35).
("Air baffle" on page 35).
Removal and replacement procedures 39