Table of Contents
Advertisement
erating modes.
Auto --- The fan automatically raises its speed in order to control inside temperature
of the fixture, if the temperature inside increases about certain level.This cycle can repeat
several times until the temperature inside is on a suitable level.
HIGH --- The cooling fan works on max. speed (max. cooling).
PA.Mo. --- Pan movement mode.Use this menu to set the character of the pan movement.
ti.Mo. --- Time mode.The pan will pass its track in time that is set on the channel 3.
SP.Mo. --- Speed mode.The pan will pass its track with the speed that is set on the channel 3
In.Po. --- Init effect positions.Select this function to adjust all effects to the desired initial positions.After switch-
ing the fixture on (if DMX is not connected),all effects will move to initial positions. Use the [UP] and [DOWN]
buttons to select desired channel and press [ENTER].Set the effect to the desired position using [UP] and
[DOWN] buttons and confirm by pressing [ENTER].After having adjusted required effects,select "Stor." to save
all values to the memory.
dF.SE. --- Default Settings .Select this option to set all fixture personalities to the default values.
8.5 Manual mode
Select this menu to call up presetted positions of channel effects or direct control channel effects.
PrE.C. --- Presetted effect control.Select this menu to call up presetted positions of the channel effects.
Man.C. --- Manual effect control.Select this menu to control effects by control buttoms on the control board.
PAn
F.PAn a fine pan movement
SPEd a pan speed
Func. pan functions
8.6 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using StageBanner 10 AT.
8.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Audi --- Music trigger.Select this function to enable the sound control of the running programs via the built-in
microphone.
Auto --- Presetting playback.This function allows you to select the program which will be played in the stand-
alone mode
after switching the fixture on.Selected program will be played continuously in a loop.
d.Abl --- The option disables "Auto" function.
tESt --- The option will start built-in test program.
PrG. 1 --- The option will start created program No.1
PrG. 2 --- The option will start created program No. 2
PrG. 3 --- The option will start created program No. 3
a coarse pan movement
16
Advertisement
Table of Contents
