Armrest - Minelab F3 Service Manual
Metal mine detector
Hide thumbs
Also See for F3:
- Service manual (77 pages) ,
- Operation manual (56 pages) ,
- Instructions manual (36 pages)
Table of Contents
Advertisement
3.8
Armrest. Figure 42 illustrates the major parts of the armrest
8013-0002 ARMREST ASSEMBLY F3
1
4002-0023 NUT M4 NYLOC SS
2
4003-0063 BOLT M4X30 SKT SS
3
4308-0003 CAMLEVER PIVOT PIN
4
3004-0015
5
3004-0015
6
8008-0005 CAM LEVER F3
7
8008-0026 PRESSURE BLOCK ARMREST F3
8
8008-0030 WEAR PLATE F3
9
8005-0018 STRAP ARMREST F3
a.
To disassemble the armrest:
●
Unlace the armrest if required.
●
Undo and remove the three bolts and nuts holding the armrest halves together.
●
Carefully pull the armrest halves apart exposing the cam lever, (Part 6), cam lever
pivot pin (Part 3), and armrest pressure block (Part 7).
●
Inspect and replace parts as required.
b.
To assemble the armrest:
●
Position the right half of the armrest onto the upper shaft.
●
Fit the armrest pressure block, cam lever pivot pin and cam lever into the right
armrest half.
●
Carefully fit the left armrest half to the right armrest half and upper shaft.
●
Refit the three bolts and nuts.
If the armrest is difficult to slide on the upper shaft, the middle bolt may need to be loosened.
F3 Field Service Manual
LEFT ARMREST HALF (part of ARMREST L+R
F3)
RIGHT ARMREST HALF (part of ARMREST
L+R F3)
Figure 42: Armrest Component Parts
NOTE
Page 31
Advertisement
Table of Contents
