Step 3 - Connecting The Shaft Assembly; Step 4 - Armrest Assembly - Minelab Quattro MP User Manual

Step 3 - Connecting the Shaft Assembly

To connect the shaft assembly to the handle assembly:
5. Release the control box
camlock lever (12) to the
open position.
6. Push the coil cable
connector into the socket
(13) underneath the handle
assembly control box.
Ensure the connector's threaded bracelet
is firmly secured.
7. Extend the lower shaft from the upper
shaft by approximately 6 inches (15cm)
to prevent the coil cable 'bunching'.
8. Push the upper shaft firmly into the control box until you
feel it has reached the back of the control box, making sure that
the control box camlock lever is in the released position.
9. Secure the upper shaft in position by locking the control box
camlock (12).
10. Adjust the shaft to the desired length for your height and
then lock with shaft camlock lever (6).
11. Tilt the search coil to the most comfortable angle, keeping in mind
it will need to be parallel to the ground during detecting.
Note: To avoid difficulty securing the control box camlock lever (step 9),
ensure the shaft camlock is released to allow greater shaft movement.

Step 4 - Armrest Assembly

To adjust the armrest assembly:
12. Loosen the screw (i) in the center of the armrest
(turning counter-clockwise).
13. Place your arm into position and slide the armrest
back (ii) so that it is comfortable under your elbow.
14. Tighten screw (clockwise) to lock into position.
2. Fitting the armrest strap
1.1.
15. Thread the strap through the buckle openings (iii).
16. Clip both buckles into the openings at each outer side
of the armrest.
17. Test by sliding your arm underneath the strap and
resting your forearm on the armrest.
18. Loosen strap by tilting the edge of the buckle out to
release it from the armrest. Undo the Velcro and pull the buckle outwards
(towards yourself.) Clip the buckle back into place and tighten the strap by pulling up.
The next time you use your detector, all you will need to do is click the buckle back
into the armrest.
www.minelab.com
p7